20
EN
Further safety instructions for all operations
Kickback and Related Warnings
Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other
accessory. Pinching or snagging causes rapid stalling of the rotating accessory which in turn causes the
uncontrolled power tool to be forced in the direction opposite of the accessory’s rotation at the point
of the binding.
For example, if an abrasive wheel is snagged or pinched by the workpiece, the edge of the wheel that
is entering into the pinch point can dig into the surface of the material causing the wheel to climb out
or kick out. The wheel may either jump toward or away from the operator, depending on direction of
the wheel’s movement at the point of pinching. Abrasive wheels may also break under these conditions.
Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can
be avoided by taking proper precautions as given below.
a)
Maintain a firm grip on the power tool and position your body and arm to allow you
to resist kickback forces. Always use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during start-up.
The operator can control
torque reactions or kickback forces, if proper precautions are taken.
b)
Never place your hand near the rotating accessory.
Accessory may kickback over
your hand.
c)
Do not position your body in the area where power tool will move if kickback occurs.
Kickback will propel the tool in direction opposite to the wheel’s movement at the point of snagging.
k)
Never lay the power tool down until the accessory has come to a complete stop.
The
spinning accessory may grab the surface and pull the power tool out of your control.
l)
Do not run the power tool while carrying it your side.
Accidental contact with the spinning
accessory could snag your clothing, pulling the accessory into your body.
m)
Regularly clean the power tool’s air vents.
The motor ‘s fan will draw the dust inside the
housing and excessive accumulation of powered metal may cause electrical hazards.
n)
Do not operate the power tool near flammable materials.
Sparks could ignite these
materials.
o)
Do not use accessories that require liquid coolants.
Using water or other liquid coolants may
result in electrocution or shock.
1. SAFETY INSTRUCTIONS
Summary of Contents for A7188-DP-1
Page 1: ...2018 01 POLISHER A7188 DP 1 EAN CODE 3276000254621 BR EN Instru esdeseguran ae jur dicas...
Page 2: ......
Page 16: ...BR 14...
Page 29: ...EN 27...