T-650, T950, T-1450
Cylinder
Step 1: Remove the top panel as described previously.
Step 2: Remove lower service panel as described
previously.
Step 3: Remove front panel as described previously.
Step 4: Remove door lock assembly. (Leave wires &
pull rod in place)
Step 5: Remove clothes door.
Step 6: Remove tub front clamp ring.
Step 7: Remove tub front. Use a flat screw driver to
pry the tub front loose.
Step 8: Remove the rear access panel.
Step 9: Remove the drive belts.
Step 10: Remove drive pulley. Remove 3 retaining
screws. Insert (3) 3/8 16 x 2” screws into the
threaded removal holes. Alternately tighten
these screws evenly to pull the pulley off.
Step 11: Remove pulley hub. Drive a flat screw driver
into the slot in the hub and pull it from the
shaft.
Step 12: Install cylinder puller. (Snap On part #CJ-
84-C) Be sure to thread a 5/8-11 NC bolt into
the end of the cylinder shaft to protect the
threads. Push the basket out.
Bearing Housing Assembly T-650, T-950 and T1450
Removal
Step 1: Remove cylinder from washer (see Cylinder (basket) removal).
Step 2: Remove 6 7/16” tub back to bearing housing cap screws.
Step 3: Remove 6 3/4” bearing housing to frame bolts.
Step 4: Remove bearing housing from frame.
Step 5: Remove the retaining ring next to the front bearing.
Step 6: The bearings are pressed into the housing and must be pressed
back out.
Reassembly
Step 1: When installing new bearings into a bearing housing, first press
the front (large) bearing into the housing until it bottoms and
install the snap ring. With the bearing spacer in place, press
the rear bearing in until the spacer is snug between the two
bearings.
Guard Ring & Mating Ring
Seals
Mating Ring & Mounting Ring
NOTE:
If the tub-back water-seal mating ring
has been moved it must be cleaned and re-
sealed
T-650, T950, and T-1450
Water Seals
Replacement
Step 1: Remove cylinder from washer (see Cylinder (basket)
removal).
Step 2: Remove water seals from the seal mounting plate
on the cylinder shaft. These are removed with your
fingers.
Step 3: The primary and secondary seals that mount on the
sealing ring may be slid over the shaft and seated on
the metal sealing ring with your fingers. In the unlikely
event that the metal ring that mounts these sealing
rings were to be damaged or moved, a new one would
need to be pressed on. The seal mounting ring must be
pushed against the stop on the shaft. After installing
the seals, lubricate the faces of the seals with silicone
grease.
Step 4: Install cylinder (see Cylinder (basket) reassembly).
Part # 8533-096-001 11/16
Part # 8533-096-001 11/16
60
61
