Loading Door Disassembly
Loading Door Reassembly
Step 1:
Remove the loading
door as outlined above.
Lay the door on a flat
surface with the glass
down
Step 2:
While holding down on
the door glass, lift up
on the door ring and roll
back the lip of the gasket
with your fingers.
Step 3:
Work all the way around
the gasket and the glass
is out.
Step 1:
Lay the door ring face
down on a flat surface.
Start the glass into one
side of the door gasket.
Step 2:
Use one hand
underneath to push the
gasket out and the other
hand on the top pulling
the gasket in place
Step 3:
The front lip of the
door gasket should
be checked for proper
seating.
Control Panel Name Plate Decal
The name plate on washer front is adhesive backed.
Control Panel Name Plate Removal
The name plate may be removed by simply peeling it off.
Re-Installation of Name Plate
Step 1:
Remove any remaining glue from the control panel.
Step 2:
Before removing the paper backing from the name plate, check fit to the control
panel. The program push buttons are the locating guides.
Step 3:
Remove the paper backing from the right side of the name plate, position it on the
panel and press right end into place. Peel the backing from the left end and press into
place.
Outer Cabinet Removal
Removal of Cabinet T-350 & T-450
Step 1:
The power supply, water hoses, and drain connection must all be disconnected before
proceeding with the disassembly.
Step 2:
Now remove the lower service panel and the top panel assembly.
Step 3:
Remove the left and right lower front panel screws that retain the panel to the
chassis.
Step 3:
Remove the bottom row of back panel screws.
Step 4:
Remove the loading door.
Step 5:
Remove the screws along the bottom of each side panel. When reinstalling these
screws do not overtighten.
Step 6:
Remove clamp and soap dispenser hose where it attaches to the tub inlet. Disconnect
the door lock wires from all switches and the door lock solenoid.
Step 7:
Disconnect pull rod between solenoid and door lock assembly. Disconnect the wires to
the dump valve at the bottom of the machine.
Step 8:
Disconnect the wires to the drive motor from the VFD T1, T2, T3.
Step 9:
Remove the clamp and the hose from the vacuum breaker where it connects to the
inlet on the back of the tub.
Step 10:
Remove the pressure switch hose from the bottom of the switch.
Step 11:
It should now be possible for two people to lift the cabinet up and off of the front of
the machine and set it aside.
58
59
Part # 8533-109-001 12/21
Part # 8533-109-001 12/21
Machine
Mounting
Installation
& Operation
Programming
Trouble-
shooting
Machine
Service
Electrical
Wiring
Parts
Data
50Hz
Parts
Maintenance
Service Elec.
Compnents