38
11. TRACEABILITY NUMBER /
SERIAL NUMBER
The Traceability Number/Serial Number will be showed in the label.
12. TROUBLESHOOTING
Machine does
not start.
1.Power cord not plugged in.
2.Power cord is damaged.
3.Circuit breaker is tripped.
4.Switch is locked at “OFF”
conditions.
1. Plug in cord.
2. Replaced at authorized
service center.
3. Reset circuit breaker.
4. Restart the tool.
Motor does
not reach full.
1. Voltage from power
source.
2. Circuit is overloaded.
3. Motor burned out.
1. Request a voltage check.
without anything else on circuit.
3. Have tool serviced and
request a voltage check.
Motor stalls,
blows fuses,
or trips circuit
breakers.
1. Switch is defective.
2. Carbon brush is wornout.
3. Voltage from source is
low.
4. Fuses or circuit breakers
are wrong size or defective.
1. Replaced at authorized
service center.
2. Replace at authorized
service center.
3. Request a voltage check.
4. Replace with a correct
circuit breaker or fuses.
Motor
overheats.
1. Motor is overloaded.
2. Grinding disc is being fed
into work too fast.
3. Air vents become
obstructed.
1. Request a voltage check.
2. Feed grinding into work
slower.
3. Clean air vents.
PROBLEM
CAUSE
SOLUTION
EN
BR
Summary of Contents for 3276000703792
