Dexter Laundry 20VAG3-125BL.1, Instruction Manual

Page: 289 / 310

FR
IT
EL
PL
ES
PT
RU
UA
BR
EN
RO
KZ
FR
IT
EL
PL
ES
PT
RU
UA
RO
KZ
EN
BR
289
wheel increases the loading and susceptibility to twisting or binding of
the wheel in the cut and the possibility of kickback or wheel breakage.
B. Do not position your body in line with and behind the rotating
wheel.
When the wheel, at the point of operation, is moving away
from your body, the possible kickback may propel the spinning wheel
and the power tool directly at you.
C. When wheel is binding or when interrupting a cut for any
reason, switch off the power tool and hold the power tool
motionless until the wheel comes to a complete stop. Never
attempt to remove the cut-off wheel from the cut while the
wheel is in motion otherwise kickback may occur.
Investigate and
take corrective action to eliminate the cause of wheel binding.
D. Do not restart the cutting operation in the workpiece. Let the
wheel reach full speed and carefully re-enter the cut.
The wheel
may bind, walk up or kickback if the power tool is restarted in the
workpiece.
E. Support panels or any oversized workpiece to minimize the risk
of wheel pinching and kickback.
Large workpieces tend to sag under
their own weight. Supports must be placed under the workpiece near the
line of cut and near the edge of the workpiece on both sides of the wheel.
F. Use extra caution when making a “pocket cut” into existing
walls or other blind areas.
The protruding wheel may cut gas or
water pipes, electrical wiring or objects that can cause kickback.
2. SAFETY INSTRUCTIONS