Dexter Laundry 20VAG3-125BL.1, Instruction Manual, Page: 285 / 310

FR
IT
EL
PL
ES
PT
RU
UA
BR
EN
RO
KZ
FR
IT
EL
PL
ES
PT
RU
UA
RO
KZ
EN
BR
285
power tool.
Operations for which the power tool was not designed
may create a hazard and cause personal injury.
C. Do not use accessories which are not specifically designed
and recommended by the tool manufacturer.
Just because the
accessory can be attached to your power tool, it does not assure safe
operation.
D. The rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool.
Accessories running
faster than their rated speed can break and fly apart.
E. The outside diameter and the thickness of your accessory must
be within the capacity rating of your power tool.
Incorrectly sized
accessories cannot be adequately guarded or controlled.
F. Threaded mounting of accessories must match the grinder
spindle thread. For accessories mounted by flanges, the arbour
hole of the accessory must fit the locating diameter of the
flange.
Accessories that do not match the mounting hardware of the
power tool will run out of balance, vibrate excessively and may cause
loss of control.
G. Do not use a damaged accessory. Before each use inspect
the accessory such as abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or accessory is dropped,
inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and
run the power tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test time.
H. Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or
workpiece fragments. The eye protection must be capable of
2. SAFETY INSTRUCTIONS