Dexter Laundry 200SHS2.5, Instruction Manual

Page: 176 / 188

1. To turn the sander on, push the O/I switch (1) forward.
2. To stop the sander, push the O/I switch (1) backward.
Switch on and off
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
6. OPERATION
176
NOTE: Always lift the sander from the work before switching on or switch off.
The sander can be used for most sanding operations on materials such as wood, plastic,
metal and painted surfaces.
Sanding
WARNING : Don’t use this machine on plaster.
Wear safety goggles and dust mask.
Where possible, secure smaller workpiece to prevent them from moving under the sander.
Lower the sander in contact with the workpiece without pressure and then start the sander.
Move the sander slowly over the surface of the workpiece in a circular or curved motion with
an even, moderate pressure.
If there are still scratches on your work after sanding, try either of the following:
- Go back to a coarser grit and sand the marks out before recommencing with the original
choice or,
- Try using new sanding sheet of the same grit to eliminate the unwanted marks before
progressing to a finer grit and finishing the job.