4
5. Plug the mouse cable end into the PS/2 mouse port
PS/2 version
If you are purchasing a PS/2 version, the receiver comes with a two -headed
cable. One is keyboard cable and the other one is mouse cable. There is a small
icon on the molding head of each cable, so you can easily recognize the
keyboard cable and the mouse cable.
Keyboard cable connector
PS/2 mouse cable connector
Selecting the ID Channel
The wireless keyboard & mouse have 256 different ID’s to avoid interference
with other users of the same model of wireless keyboards or mice. Before using
the wireless keyboard and mouse, you must ensure that the same ID is set for the
receiver, keyboard and mouse.
Please follow the steps as below to set up:
Step 1. Installing the Batteries
This RF wireless keyboard uses a AA battery. To apply the battery, please
follow the steps below:
1. Turn the keyboard to the upside down.
2. Remove the battery cover by pressing the two tabs and pulling the cover up.
3.
There are signs to indicate the placement of the batteries positive and
negative poles. Follow these signs very carefully to insert the batteries
properly.
Improper insertion of the batteries may cause damage to the
keyboard.
4. Place the batteries cover back and make sure it is firmly closed
Step 2.
1.Turn to the bottom of the receiver and you will see a small rectangular hole
(take the cover as Fig-1) and a tact switch ID code connection.
Step 3.
Establish communication between the
receiver and the mouse (select
identification codes).
??
Press and release the
“connect” switch on bottom of
the receiver.
??
Within about 6 seconds of the
previous step, press and release the “connect” switch on the top-
right of the keyboard.
??
Now the same ID is selected on both of the receiver and the
keyboard.
Please press any key of the keyboard to check if it works. If there is problem,
please repeat the connection setting procedure once
again or check the troubleshooting guide.
Step 4. Installing the Software
PLEASE READ THIS BEFORE YOU INSTALL ANY DRIVER
Before installing the mouse driver, it is strongly recommended that you remove
all other mouse drivers and application programs
1. Insert the software CD into your CD-ROM drive.
2. The installation program should start automatically. However, if the program
does not start automatically, simply locate the ‘setup.exe’ file in the CD’s
main directory and double -click on its icon to continue the installation
procedure.
3. Follow the on-screen instructions.
PLEASE NOTE
: After software installation, your keyboard should
automatically function in any Windows environment. The wireless mouse
controller will be automatically detected by window 95,NT, 2000, ME or XP.
To Uninstall the Software
1.
Keyboard Multimedia Functions-
From the Windows Start Menu, locate
the Uninstall program under Programs \Media key\, and click on Uninstall
Media key to uninstall the keyboard software.
PLEASE NOTE:
The Media key application should be closed first before
you uninstall the multimedia functions.
2.
Mouse Scrolling Functions-
From the Windows Start Menu, locate
Uninstall program under Programs \Wireless Scroll Mouse V1.20\, and double -
click on Uninstall Wireless Scroll Mouse to uninstall the mouse software
Hot-Key Functions
Note: Please make sure that both hardware and software are correctly installed
in your system before proceeding to use the Multimedia Keys.
The Multimedia Keys on the keyboard are labeled as follows:
Fig-1
