Pro-Series Operation
3A8110C
19
Pro-Series Operation
Programming the Pump
The Pro-Series features a program/repeat
button that allows the user to program a
volume of material they want to repeatedly
dispense. After programming the unit, the
pump will repeat that volume with a single
press and release of the repeat button.
To program the pump, follow the steps below.
1.
To enter program mode, press and hold
down the repeat button for two seconds
until the red LED light begins to blink.
2.
While the LED light is blinking, press the
dispense button until the desired amount
of material is pumped. This can be one
continuous press, or numerous presses
of the dispense button.
3.
While the LED light is still blinking, press
and release the repeat button to set the
program for that volume of material and
to exit programming mode. This must be
completed within 10 seconds of
releasing the dispense button or it will
not save the program.
4.
To pump the programmed volume, press
and release the repeat button. If the
button is held longer than two seconds,
unit will revert back to programming
mode.
5.
If you want to interrupt the pumping,
press any button and the unit will stop.
The next press of the repeat button starts
the program over.
Summary of Contents for Graco PowerFill 3.5 Standard 26B417
Page 39: ...Graco Information 3A8110C 39 ...
