22
EnGLIsh
2. Remove the wheels.
3. Remove the pivot pin
28
.
To attach the wheels to the base, reinsert the pivot pin, slide
the wheels on their axles and secure the clips in place. Make
sure all four wheels are securely attached before using the
cutting shroud.
OPERATION
Instructions for Use
WARNING:
Always observe the safety instructions and
applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories.
Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Tuckpointing and Cutting Application
(Fig. A, J)
1. Set the desired depth of cut, see
Depth of Cut Adjustment
under
assembly and adjustments.
2. Allow the tool to reach full speed before touching it to the
work surface.
3. Position yourself so the open underside of the shroud and
the wheel are facing away from you.
4. Place the metal base
3
of the shroud onto the work surface
and begin cut by plunging into the work surface. The upper
shroud
9
will lock onto the lower shroud
10
after the
initial plunge.
nOTE:
Keep the metal base of the shroud against the work
surface to ensure proper dust collection.
5. With the shroud oriented as shown in Figure J, pull the
grinder along the work surface.
nOTE:
The grinder should ONLY be used in the
direction indicated.
6. When finished with the cut, remove the tool from work
surface before turning off the tool. Allow the tool to stop
rotating before laying it down.
7. Push the side shroud button
8
to release the upper shroud
and start a new plunge and cut.
MAINTENANCE
Your
D
e
WALT
power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories.
Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING:
Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING:
Since accessories, other than those offered
by
D
e
WALT
, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
D
e
WALT
recommended
accessories should be used with this product.
WARNING:
Accessories must be rated for at least the
speed recom mended on the tool warning label. Wheels
and other accessories running over rated speed can fly
apart and cause injury. Accessory ratings must always be
above tool speed as shown on tool nameplate. Select an
appropriate blade for the cutting application.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com
.
