English
7
Operation of Slide Table
1. Install miter gauge in “T” slot in slide table in desired
location and angle. Adjust miter gauge fence approxi-
mately 1” from blade.
2. Tighten miter gauge lock knob on left side of slide table.
3. Move slide table toward operator and ensure that work
piece will clear blade. Cycle slide table and ensure that
end of miter gauge fence goes past blade centerline
and does not contact blade or blade guard.
4. Move slide table toward operator, place work piece on
slide table. Engage hold down clamp if needed. If using
flip stop, hold piece securely against flip stop and miter
gauge fence. Keep hold down clamp centered over
miter gauge bar. Do not overtighten clamp.
5. Turn on saw. Push slide table and work piece through
blade. Do not stand directly behind blade.
6. Turn off saw. Remove work piece. Return slide table to
home position.
Adjust the rear fence glide
If necessary, adjust the rear glide to locate it correctly
against the rear rail by loosening the two screws which
secure it to the fence beam. The plastic retaining clip
should be deflected somewhat when the glide is posi-
tioned correctly. This adjustment should only be neces-
sary if the rear rail has been relocated by the addition of
an optional accessory.
Cleaning
Cleaning Slides:
STEP 1. Push Slide Table rearward as far as it will go.
Gently sweep sawdust off of slide table support pan.
Return slide table to its parked position.
STEP 2. To clean ball bearing slides, move slide table as
far forward as it will go. Using clean rag, gently wipe
exposed ball tracks on slides attached to support pan.
Look under slide table, gently wipe exposed ball tracks
on slides attached to underside of table. Push slide
table as far as it will go in other direction. Again, wipe
exposed ball tracks on slides attached to support pan
and underneath table.
Cleaning Slide Table:
•
Protect your investment. Keep your slide table clean.
If you notice signs of rust on the table, steel wool the
areas. Clean with mineral spirits or denatured alcohol
and apply paste wax.
