23
FIG. 42
VV
UU
Dust Collection
Your table saw is equipped with a dust shroud and dust collection port. For best
results, connect a vacuum to the port at the rear of the saw.
After extended use, the saw’s dust collection system may become clogged. To clear
the dust collection system:
1. Unplug the saw.
2. Turn the saw on its side, so the bottom, open part of the unit is accessible.
3. Open the dust access door (UU) shown in Figure 42 by removing the wing
screws (VV). Clean out the excess dust, and re-secure the access door with the
wing screws.
FIG. 43
Lubrication
1. All motor bearings are permanently lubricated at the factory and no additional
lubrication is needed.
2. The height adjustment gear may require periodic cleaning and lubrication
(Fig. 43). If you have difficulty raising or lowering the blade, contact a D
E
WALT
authorized service center.
Storage (Fig. 44, 45)
A4
FIG. 44
Q
GG
1. Attach push stick (U) to fence.
2. Remove Blade guard assembly (D).
Refer to
To Remove Blade Guard
Assembly.
Slide Blade guard
assembly into brackets as shown.
3. Depress the stem (GG) on the anti-
kickback assembly (Q) to allow the
assembly to slide from the riving knife
slot.
4. Position anti-kickback assembly into the storage hole as shown. While depressing
stem (GG) slide the anti-kickback assembly across the storage slot (A4) and release
pin to lock into place.
5. Loosen the riving knife lock knob (YY, Fig. 24) (minimum of three turns).
6. Push riving knife lock knob (YY) toward the riving knife as indicated by the yellow
arrows on the knob to disengage riving knife lock pin.
7. Lift and slide the riving knife from saw.
8. Remove wingnut securing blade wrenches. Place riving knife (FF) onto post with blade
wrenches (V) and secure with wingnut.
