DeWalt DE730, Manual

Page: 14 / 44

E N G L I S H
en - 3 9
Using a tape measure (fig. A & F)
The DE730 allows you to use a standard tape measure (with belt clip) to
measure the cutting width. The instructions below assume that the length
stop is located to the left of the saw. If it is located to the right of the saw,
follow the same instructions, replacing left by right and right by left .
• Slide the length stop to a distance of approx. 1 m from the saw blade
and lock it in place.
• Set the saw blade to a 90° angle to the rail.
• Lock the saw mounting board in place by tightening the locking
knobs (3) (fig. A).
• Measure the distance between the right edge of the length stop and
the left edge of the saw blade. Note the distance measured.
• Mount the tape measure (24) on the length stop (25) as shown (fig. F).
• Pull the tape out and flip the stop down.
• Guide the tape under the horn of the material support (26) and through
the tape clamp (27).
• Loop the tape back so that it rests on the rail as shown.
• Pull the tape out until the measurement shown at the right end of the
length stop matches the distance noted.
• Tighten the clamping screw (28).
• To verify the adjustment, slide the length stop to a specific measure
and make a trial cut. The length of the cut-off piece should match the
reading on the tape measure. If not, re-adjust as described above.
Consult your dealer for further information on the appropriate accessories.
Maintenance
Your D
E
WALT attachment has been designed to operate over a long
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Lubrication
Your attachment requires no additional lubrication.
Unwanted products and the environment
Take your attachment to an authorized D
E
WALT repair agent where it will
be disposed of in an environmentally safe way.
GUARANTEE
• 30 DAY NO RISK SATISFACTION GUARANTEE •
If you are not completely satisfied with the performance of your
D
E
WALT tool, simply return it within 30 days, complete as purchased,
to the point of purchase, for a full refund or exchange. Proof of
purchase must be produced.
• ONE YEAR FREE SERVICE CONTRACT •
If you need maintenance or service for your D
E
WALT tool, in the
12 months following purchase, it will be undertaken free of charge at
an authorized D
E
WALT repair agent. Proof of purchase must be
produced. Includes labour and spare parts for the attachments.
Excludes accessories.
• ONE YEAR FULL WARRANTY •
If your D
E
WALT product becomes defective due to faulty materials or
workmanship within 12 months from the date of purchase,
we guarantee to replace all defective parts free of charge or, at our
discretion, replace the unit free of charge provided that:
• The product has not been misused.
• Repairs have not been attempted by unauthorized persons.
• Proof of purchase date is produced.
This guarantee is offered as an extra benefit and is additional to
consumers statutory rights.
For the location of your nearest authorized D
E
WALT repair agent,
please use the appropriate telephone number on the back of this
manual.