English
9
WARNING:
Shock hazard. Do not allow any liquid to get inside the
charger. Electric shock may result.
CAUTION:
Burn hazard. To reduce the risk of injury, charge only
D
E
WALT rechargeable battery packs. Other types of batteries may
overheat and burst resulting in personal injury and property damage.
NOTICE:
Under certain conditions, with the charger plugged into the
power supply, the charger can be shorted by foreign material. Foreign
materials of a conductive nature, such as, but not limited to, grinding
dust, metal chips, steel wool, aluminum foil or any buildup of metallic
particles should be kept away from the charger cavities. Always
unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug the charger before attempting to clean.
•
DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual.
The charger and
battery pack are specifically designed to work together.
•
These chargers are not intended for any uses other than
charging D
E
WALT rechargeable batteries.
Any other uses
may result in risk of fire, electric shock or electrocution.
•
Do not expose the charger to rain or snow.
•
Pull by the plug rather than the cord when disconnecting
the charger.
This will reduce the risk of damage to the electric
plug and cord.
•
Make sure that the cord is located so that it will not be
stepped on, tripped over or otherwise subjected to damage
or stress.
•
Do not use an extension cord unless it is absolutely
necessary.
Use of improper extension cord could result in risk of
fire, electric shock or electrocution.
•
When operating a charger outdoors, always provide a dry
location and use an extension cord suitable for outdoor
use.
Use of a cord suitable for outdoor use reduces the risk of
electric shock.
•
An extension cord must have adequate wire size (AWG
or American Wire Gauge) for safety.
The smaller the gauge
number of the wire, the greater the capacity of the cable, that is,
16 gauge has more capacity than 18 gauge. An undersized cord
will cause a drop in line voltage resulting in loss of power and
overheating. When using more than one extension to make up the
total length, be sure each individual extension contains at least the
minimum wire size. The following table shows the correct size to
use depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The lower the gauge number,
the heavier the cord.
Minimum Gauge for Cord Sets
Ampere Rating
Volts
Total Length of Cord
in Feet (meters)
120V
25 (7.6)
50 (15.2) 100 (30.5) 150 (45.7)
240V
50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
More
Than
Not More
Than
AWG
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Recommended
•
Do not place any object on top of the charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat.
Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
•
Do not operate the charger with a damaged cord or plug.
•
Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way.
Take it to
an authorized service center.
