ENGLISH
53
Battery Pack (fi g. 2)
BATTERY TYPE
The DC413 operates on 28 volt Li-Ion battery packs.
The DC415 operates on 36 volt Li-Ion battery packs.
Storage Recommendations
1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
NOTE:
Li-Ion battery packs should be fully
charged when stored.
2. Long storage will not harm the battery pack or
charger. Under proper conditions, they can be
stored for up to 5 years.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual before use
See
Technical Data
for charging time.
Do not expose to water
Do not probe with conductive objects
Do not charge damaged battery packs
Do not use damaged chargers
Charge only between 4 °C and 40 ˚C
Have defective cords replaced
immediately
Charger
problem
Battery
problem
Discard the battery pack with due care for
the environment
Do not incinerate the battery pack
Charge only with dedicated D
E
WALT
chargers
Package Contents
The package contains:
1 Angle grinder
1 Type 27 guard
1 Anti vibration side handle
1 Flange set
1 Two-pin spanner
2 Battery packs (DC413KL/DC415KL)
1 Battery charger (DC413KL/DC415KL)
1 Kit box (DC413KL/DC415KL)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 4)
WARNING:
Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger switch
b. Lock-Off Button
c. Spindle lock button
d. Side handle
e. Abrasive wheel
f. Anti-lockup backing flange
g. Threaded clamp nut
h. Type 27 guard
i.
Battery
pack
j. Battery release button
INTENDED USE
The DC413/DC415 heavy-duty angle grinders have
been designed for professional grinding, cutting,
wire-brush and sanding applications.
DO NOT
use grinding wheels other than centre
depressed wheels and flap-disk.
DO NOT
use under wet conditions or in presence of
flammable liquids or gases.
