18
CAUTION
: Matching diameter backing flange and threaded clamping nut (included
with tool) must be used for cutting wheels.
1. Place the unthreaded backing flange on spindle with the raised section (pilot)
facing up. The raised section (pilot) on the backing flange will be against the
wheel when the wheel is installed.
2. Place the wheel on the backing flange, centering the wheel on the raised section
(pilot).
3. Install the threaded clamp nut with the raised section (pilot) facing away from the
wheel.
4. Depress the spindle lock button and tighten clamp nut with
a wrench.
5. To remove the wheel, depress the spindle lock button and loosen the threaded
clamp nut with a wrench.
USING CUTTING WHEELS
WARNING:
Do not use edge grinding/cutting wheels for surface grinding
applications because these wheels are not designed for side pressures encountered
with surface grinding. Wheel breakage and injury may result.
1. Allow tool to reach full speed before touching tool to work surface.
2. Apply minimum pressure to work surface, allowing tool to operate at high speed.
Cutting rate is greatest when the tool operates at high speed.
3. Once a cut is begun and a notch is established in the workpiece, do not change
the angle of the cut. Changing the angle will cause the wheel to bend and may
cause wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow the tool to stop
rotating before setting it down.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/installing
attachments or accessories.
Lubrication
D
E
WALT tools are properly lubricated at the factory and are ready for use.
Cleaning
WARNING:
Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING:
Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING:
Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
This charger is not user serviceable. There are no user serviceable parts inside the
charger.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING:
Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
E
WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory,
please contact D
E
WALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark,
VIC 3138 Australia or call 1800 654 155 or (NZ) 0800 339258.
Summary of Contents for DC411-XE
Page 1: ...DC411 XE CORDLESS FINISHING GRINDER INSTRUCTION MANUAL ...
Page 2: ......
Page 22: ...20 ...
Page 23: ...21 ...
