19
English
CoDe
PossIble CAuse
PossIble solutIon
4
Defective air tank
Air tank must be replaced. Do not repair the leak.
WARNING: Risk of bursting. Do not drill into, weld or otherwise
modify air tank or it will weaken. The air tank can rupture or
explode.
5
Leaking seals
Contact a D
e
WALT factory service center or a D
e
WALT autho-
rized service center.
6
Defective safety valve
Operate safety valve manually by pulling on ring. If valve still
leaks, it must be replaced.
7
Regulator is not adjusted correctly for accessory
being used
It is normal for some pressure drop to occur when an accessory
is used, adjust the regulator as instructed in
regulator under
Features if pressure drop is excessive.
note:
Adjust the regulated pressure under flow conditions
while accessory is being used.
8
Prolonged excessive use of air
Decrease amount of air usage.
9
Compressor is not large enough for accessory
Check the accessory air requirement. If it is higher than the
CFM or pressure supplied by your air compressor, a larger com-
pressor is needed to operate accessory.
10
Hole in air hose
Replace air hose.
11
Check valve restricted
Remove, clean or replace.
12
Air leaks
Tighten fittings.
13
Regulator is damaged
Replace.
14
Motor overload protection switch has tripped
Refer to Motor overload Protection under Features. If motor
overload protection trips frequently, contact a D
e
WALT factory
service center or a D
e
WALT authorized service center.
