Website:
www.devicewell.com
Email:
20
HDS6112
After the device is wired, input SDI camera 1 and camera 2, the default will be displayed in
the red mark 1 and 2 position in the figure below; then press 1 and 2 respectively in the PVW and
PGM areas of the control panel, then the PVW and PGM boxes above will display
correspondingly. Signal source.
Key setting
Then press the AUTO, CUT, or manually push the fader on the control panel to switch.
Among them, AUTO can be set to switch effects, CUT is hard cut, no transition effect, manual
putter can set special effects, and push speed is proportional to the speed of switching.
Note: In the process of switching between AUTO or fader, if the 1 button of PGM and the 2
button of PVW are both red, the channel for switching PGM or PVW is invalid. As shown below
2
1
1
2
