Website:
www.devicewell.com
Email:
19
HDS6112
7.3
PGM&PVW Switching
7.3.1
T-bar Calibration
When the switcher is in use, the fader misalignment may occur, and the origin of the switcher
fader is offset. Therefore, the switcher pushrod system should be calibrated before use.
First press the 1 and 2 buttons in the PGM area simultaneously with the device turned off. As
shown below:
Note: The 1 and 2 keys cannot be released during the calibration process.
Turn on the power switch again, and the indicator light next to the push rod will light up in
sequence after the power is turned on, as shown below.
At this time, push the T-bar back and forth until the indication is normal. (All lights up or all
lights down) as shown below.
The picture on the left shows the
status of the push indicator light
from bottom to top.
If the display on the left indicates that the
calibration is complete, you can release the 1
and 2 buttons that were previously pressed.
