Customer Documentation DEV 5071
20
Copyright DEV Systemtechnik GmbH 2007-2017
After successful authentication, the configuration program of the device is
launched. After start and after the finalization of most of the choices the
program lists the choices, which can be performed with the program:
config
======
1 set IP address (192.168.0.225)
2 set netmask (255.255.0.0)
3 set gateway (192.168.0.99)
q quit without saving
x save configuration and exit
your choice >
Choices can be executed by typing the character in the first column of each
line followed by a
<CR>
. The second column of each line provides a short
description of the choice and the third column displays in parentheses the
current setting of the corresponding choice. In the example above, the IP
address and the netmask are different from the factory default network
settings (please refer to chapter 4.3.2).
When using the "
q
" choice, the configuration
program terminates and the
login message is displayed again:
(none) login:
When using the "
x
" choice, the configuration
program saves all changes
made and reboots the device:
(...)
your choice >
x
<CR>
rebooting the device, please wait...
When rebooting, all processes are stopped and the reboot of the device is
initialized. After a reboot, it takes a few moments before the serial interface
is accessible again as described at the beginning of this chapter.
In the following, the available choices are explained:
4.4.2.2.2
1 set IP address
This choice is used to change the IP address of the device:
(...)
your choice >
1
<CR>
Current IP address is 192.168.0.225
Enter IP address ('NONE' to clear) >
To change the current IP address, type in a different valid address; to clear
the address, type in "
NONE
<CR>
"; and just entering
<CR>
maintains the current
setting:
Enter IP address ('NONE' to clear) >
<CR>
unchanged
After that the choices list reappears.
