CAUTION
PROPERTY DAMAGE HAZARD
Failure to follow this caution may result in water
spillage and/or property damage.
For
any
position
other
than
upflow,
the
multiposition pressure switch must be connected
pneumatically
to
the
condensate
box
and
electrically to the control to allow the furnace
to stop in the event of drain blockage.
Figure 2 – Panel Identification
Figure 3 – Dimensions
Figure 4 – Top view
Figure 5 – Drain Trap Localisation
Figure 6 –
Pressure switch connections for
multipositions
4.1
UPFLOW
The condensate trap must be outside the furnace casing.
Use the 3 port drain trap. The condensate drain hoses
must be routed to the trap through the furnace casing.
Remove the metal knock out on the side of the casing
and route the hoses to the drain trap. Refer to Figure 5.
4.1.1
Uplow Condensate drain connection
1. Remove the knock out from the side of the casing.
See figure 5 for drain trap location in the upflow
9
Summary of Contents for CC15-M-V
