Blitz-DT9 User Manual
- 14 -
After power on, you will see the initialization interface in LCD as the following
figure. The transmitter's LED indicator stays illuminated at the same time.
Wait for about 2 seconds, the LCD will enter the main screen.
If the throttle stick is not at the lowest position, after turning on the power
switch, the LCD will display the prompt information. Lower throttle stick to the
lowest position, the information will disappear and the LCD will enter the main
screen.
Turn off the transmitter:
1. Turn off the power switch, the transmitter shut down at once.
Charging the Transmitter
Blitz DT-9 has an internal charger designed to charge the battery. The charge
port is on the right side of the transmitter.
Steps:
1. Connect the charge cable to the transmitter charge port.
2. Connect the other end of charging cable to a power outlet using the
appropriate adapter.
Charging the transmitter when it is off, the LCD display will show charging
status and the current battery level. Charging the transmitter when it is on, the
battery level will be showed in the top right corner of the main screen.
User still can operate the transmitter on charging process.
3. Disconnect the charging cable when the battery is full charged.
Binding
In order for the transmitter and receiver to communicate, it is essential to pair or
bind them together. When you use the R/C system first time or change a
transmitter/receiver, this procedure is necessary. Each transmitter has an
individually assigned, unique ID code. Once the binding is made, the ID code is
stored in the receiver and no further binding is necessary after restarting the
receiver.
Preconditions:
