NOTE
: Prior to installing the reflector, relocate the saw horses to support the burner control box and the
tubes beneath the u-end reflector.
1
Align the reflector end cap holes (2) with the corresponding U-end end studs (see Detail ‘C’-Step 1).
NOTE
: Do not remove the existing nuts on studs.
2
Lower the burner box end cap down over the tubes while shifting the reflector assembly towards the
U-end. (see Detail ‘C’-Step 2).
3
Secure burner reflector end cap with (2) 5/16”-18 keps nuts (see Detail ‘D’). Note: The burner reflector
end cap does not have a tab with slots.
4
Secure the U-end reflector end cap using the red shoulder screws provided (see Detail ‘E’).
5
Repeat process with remaining reflector assembly.
Installing the Reflector Assembly
DETAIL ‘D’
Secure burner reflector end cap
(TP-6085A) with (2) 5/16”-18 keps
nuts per assembly.
DETAIL ‘E’
Secure the U-end reflector end cap
using the #8 x 1/2” red shoulder screws
(TP-6086A). Two per assembly.
Step 2
Step 1
DETAIL ‘C’
Figure 3.4
•
Final Heater Assembly
QTD2
Series
14
3.0
Installation
•
Installing the Reflector Assembly