MW2
Series
12
2.0
Installation
•
Top Channel Assembly
Top Channel Assembly
1
Attach the mounting brackets to the top wire raceway. On each end, place (1) 1/4” x 1/2” bolt
through the bottom hole of the mounting bracket and through the bottom hole of the top wire
raceway. Place (1) 1/4” lock nut on each bolt. Do not tighten completely. Refer to Figure 2.4.
NOTE
: The mounting brackets are
NOT
required for chain suspension.
2
Adjust wire raceway to desired mounting angle.
3
On each side, place (1) 1/4” x 1/2” bolt through slot in the mounting bracket and the hole in the top
wire raceway. Place (1) 1/4” lock nut on each bolt and tighten.
4
Tighten lock nuts from Step 1.
5
Hook heater body into mounted wire raceway. Unit will hang freely by the “T” hinge, leaving both
hands free to wire unit. Refer to Figure 2.4.
6
Run supplied high temperature wires out to field supplied junction box.
DO NOT
make connections
inside the wire raceway.
7
Close wire raceway using the (4) #8-32 x 3/8” grounding screws provided in hardware pack.
Figure 2.4
•
Top Channel Assembly
Wire Raceway
#8-32 x 3/8”
Screw
1/4” x 1/2” Bolt
#8-32 x 3/8” Grounding Screw
