104918 sheet 3
Adjust width as
required to fit gate
This edge to hinge
side of gate
For added security & for large gaps between gate
and post, use Gate Latch Protector.
Mounts between gate and plate to cover gap.
STEP 2:
Install plate assembly using 3 tek screws per side.
Plate assembly mounts to INSIDE of gate.
STEP 1:
Mark the BOTTOM of the PLATE
28"
from the floor/ground
Note: Strike bracket acts as the gate stop
STEP 3:
Install strike bracket
using acorn nuts
& flatwashers
Installing the Adjustable Gate Plate
Tools required: Safety glasses, Pencil, Level, Power drill, Screwdriver, Tape measure
TOP VIEW
40" from
floor/ground
Latch side
of gate
U-Bolt
28"
Drain holes need
to be on the bottom
7-3/4" MAXIMUM if using
optional 03GS Lockbox
Approximately
1" overlap (varies with gate construction)
Tighten nuts after
positioning bracket
Hinge side
