SSP-5000G
9
BATTERIES
Your detector is provided with built-in rechargeable battery pack - NiMH batteries, 1800
mAh. These batteries have no “memory” - they could be recharged at any time, with no
request to be fully discharged.
NOTE: The NiMH battery pack supplied with your detector is charged, so it is not
necessary to charge it before the first use of
your detector. The batteries will reach their full
capacity after numeral charge/discharge cycles.
The battery condition is constantly shown by a
a battery symbol in the upper right end of the
display.
To recharge your detector, please, plug the mains
charger plug into the COIL/CHARGER coupling
on the rear panel. Then plug the mains charger
into the wall socket. The detector starts charging. But to be able to see the process,
press ON/OFF button. If the battery is not charged, on the screen will appear a text
BATTERY
CHARGING
BATTERY HAS
BEEN CHARGED
CHARGING BATTERY and a symbol of a recharging battery. When the battery is fully
charged the text BATTERY HAS BEEN CHARGED will appear and the battery symbol
will show a fully charged battery.
On the rear panel there is also a coupling for external power supply. When you switch
on an external power supply its voltage should not be more than 12V, and please, keep
to the polarity given on the rear panel.
NOTE: No matter whether you use external, or the internal power supply, if the voltage
of the batteries decrease below the appropriate level the detector will warn you with an
inscription on the display THE BATTERY IS LOW. PLEASE CHARGE IT.
To extend your battery’ life use headphones.
Summary of Contents for SSP-5100 G
Page 1: ...SSP 5100 G...
Page 14: ......
