DESSALATOR DUO100, User Manual

Page: 5 / 21

- Page 1 -
1. Components supplied with the Dessalator®:
Version A3
Hull valve:
It must be located the lowest possible in the boat, to the back for a
motor yacht or in the centre near the keel for a sailing boat.
The hull valve strainer filters out the larger particles at system
entrance.
Pre-filter:
It must be located the nearest possible to the hull valve and be
compulsory under the waterline. If not possible, there is a
solution: to install a LP pump (optional).
The pre-filter filters out solid particles down to 5 µm at the motor
unit inlet. It is supplied with wrench. For automatic rinsing, an
electro valve is mounted.
Motor unit:
It must be located compulsory under the waterline.
The motor unit is comprised of the 12 or 24 V motor and
the 120 or 230 V motor.
It should be installed in a well-
ventilated space . BEWARE : In 120V , please think of an
even more important ventilation of the motor unit
than in 230V.
Membrane unit:
The membrane unit includes 3 membranes 2521
assembled in a compact frame.
According to the model, a fuse or a circuit breaker is supplied.
Control panel:
includes a HP gauge, a flowmeter, an on/off switch, a pressure
adjustment knob, an operating time meter, 3 indicator lights.
Pipes and hoses supplied by Dessalator®:
-
High pressure pipes pump/membranes and membranes/control panel (2 pipes and 4 special
connectors)
- Water production pipe membrane / control panel.
Additional hardware needed for assembly:

Miscellaneous screws (including Parker)

Stainless jubilee clips

10mm and

12mm

Assortment of plastic rings (tie wraps)

Teflon tape or insulating water proof tape

Silicon Rubson mastic, Sicaflex or equivalent

Ribbed insulating pipe for cables and HP tubes

Tricoflex hoses

10mm and

12mm

Power cable: 35mm² for the 12V and 20mm² for the 24V

Various tools (electric drill, saw, …)