Page 15
sets the starting method. The factory setting uses “No-Tach”
starting. If you wish to use the tach to start, follow the instruc-
tions in 12A.
is for the choice of run times.
will add 50% more crank time to “No-Tach” starting.
adds 100% more crank time. This is necessary on many deisel
and hard to start vehicles. Options #3 and #4 can be added
together for even more cranking time.
is used in the “No-Tach” starting method for some diesel ve-
hicles.
option must be activated when installing on a diesel vehicle.
cancels the Enable mode safety feature. The Enable mode
re-
quires that the driver toggle the ON/OFF control switch “OFF”
then “ON” in order to “enable” the vehicle for Secure Start®
control. This feature guards against undesired starting of the
vehicle by remote control.
Normal Trigger will start and stop the Secure Start with a single
quick ground pulse to the Remote Input wire of Step 13. Double
Pulse Trigger mode will not activate the Secure Start until it
has seen two pulses within 3 seconds time. Thus if you hook
the Remote Input wire up to the Door Lock wire of your keyless
entry module -- you can lock the doors with just one push of the
transmitter’s Lock button. If you push transmitter’s Lock but-
ton again within 3 seconds -- you will lock AND start the ve-
hicle.
ING PROGRAM OPTIONS:
ant the factory setting, DO NOTHING and skip this section. If
nt to change to one of the options, TURN THE ON/OFF
OL SWITCH TO THE “OFF” POSITION. Wait for the red
stop flashing, then continue with the following procedures:
ush the button to the left of the red LED. Each time you
ush the button the red LED will flash 1 to 8 times signify-
Page 16
ing at which option you are (press it once, the LED fla
once. Press it again and it will flash two times. Pre
again and it will flash three times, etc., to show what op
you are at).
B. When you are at the option level you desire, push the
button for a second and the red LED will flash once for
tion setting and Twice for Factory setting.
C. You can choose the next option by pushing the left bu
again to index to the next option. When you get to the
option you want to change, simply repeat Step B above.
ter six seconds, the Secure Start® automatically exits the
gramming mode (Three LED flashes).
D. Turn the Control Switch back ON and confirm that the L
flashes once as the switch is turned ON.
SPECIAL CASES
1) VATS system (for new GM cars with special PASS key).
If you have a GM vehicle with a factory anti-theft system (a r
the key), you need to follow these directions:
Measure the resistance of the key. It should be between 392 o
11,800 ohms. To do this, put the ohm meter probes on each si
key pellet. This value should be close to one of the following (a
in ohms): 392, 523, 681, 887, 1.13K, 1.47K, 1.87K, 3.01K, 3.74K
6.04K, 7.5K, 9.53K, 11.8K. Purchase a resistor with a value w
of this measured value and a 30 amp BOSCH type relay.
