Page 7
ue Wire (14 AWG)
Ignition 1
the LIGHT BLUE wire to the ignition 1 wire of your vehicle.
e will m12V on the test meter in the “run” and “start”
and is off (ground) in the “lock/off” and “accessory” position).
een (14 AWG)
Ignition 2
the GREEN wire to the second IGN2 wire of your vehicle. This
nd wire that is hot in the “run” and “start” position only.
hite Wire (14 AWG)
Accessory / Lights
the WHITE wire to the accessory wire which is +12V in the
osition, but off (ground) in the “start”, “off” and “accessory”
. This wire will power the heater/air conditioner (in most cars).
HITE wire can also be used as the headlights wire if you do not
or the Accessory position -- or if you power the heater / air condi-
th the GREEN IGN2 wire. Simply connect this WHITE wire to
eam connection of the headlights or to the parking lights. Do not
wire for to power both Accessory AND Headlights together un-
use 2 external relays powered by this WHITE wire -- one for the
ts and the other for the Accessories.
low (14 AWG)
Starter
the YELLOW wire to the starter wire. This wire is hot in the
osition only.
issan vehicles have two starter wires. Connect both starter wires
ELLOW wire.
Page 8
Control Harness (All wires are the smaller 18 AWG
8. Red/Black On/Off Switch
Control Ha
The Red/Black wire from the control harness must be connecte
side of the On/Off control switch provided in the parts kit (us
connectors). The other side of the switch must be connected to
When the Red/Black wire of the switch is resting at ground (in th
position), the Secure Start® will not start the vehicle.
Note:
Mount the control switch so that the colored dot is
upward (“ON”). Connection of this switch is mand
9. Violet Wire Hood Pin Switch
Control Ha
The hood pin switch MUST be installed with the Secure St
prevents operation of the Secure Start® when the hood is open.
the VIOLET wire to the hood pin switch using the red connec
Note:
If you already have a hood pin
switch which is being used by
a car alarm system, you may
share the wiring -- but be
sure to diode isolate each
wire going to the hood
pin switch with the
bands of diodes point-
ing towards the pin
switch as follows:
