Page 5
!! WARNING !!
with airbags, you may notice bright yellow tubes or harnesses
ath the steering column area. DO NOT tamper with these wires in
so as to prevent personal injury and/or damage to the air bag
gases are explosive. Do not smoke while working near the car’s
!!CAUTION!!
orking the wires through the car’s firewall, be sure to protect
m sharp metal edges and from hot surfaces on the engine.
Some installers connect a battery charger to the vehicle’s battery
nstallation. This is fine, but it must be removed before running
cle under Secure Start® control.
INSTALLATION INSTRUCTIONS
ore You Start
e time to read through the whole installation manual.
arnesses: Before installation, always check that your wire
matches the list/drawing on page 4 of the manual.
RTANT: After having read the entire manual, start the
on by putting the yellow WARNING STICKER in the engine
ment. Choose a surface that is clean and readily visible when the
open.
Page 6
POWER & IGNITION WIRES
The Secure Start® module will be installed under the dash once
ing has been completed. Do not mount the module at this ti
will need to check the diagnostic light (LED) as the inst
progresses. Locate (or drill) a hole in the firewall to run the V
(hood) and the GREEN (tach) wires of the Control Harness and t
wire of the Power Harness through into the engine compartme
remaining short wires stay in the passenger area. Leave about
the wire harness under the dash for ease of working and visual
the diagnostic lights.
Note:
Always connect the Black and Pink wires before con
any of the other wires.)
2. Black Wire (14 AWG)
Gr
Connect this BLACK wire to a very good, clean chassis grou
driver’s kick panel area. Use the small red ring terminal if ne
The metal bracing around or beneath the dash board is not ad
3. Pink Wire (12 AWG) Power (
Connect the ring terminal at the end of the short PINK wire to
volt terminal of the battery. Insert the silver tab at the end of
PINK wire into the black fuse holder. They go in only one way,
will snap in permanently. Now insert the 30 amp green fuse
holder. As you connect this wire to the module, the RED LED
flash once.
Note:
Note:
Note:
Note:
Note:
Failure to properly install the fuse holder and 3
Failure to properly install the fuse holder and 3
Failure to properly install the fuse holder and 3
Failure to properly install the fuse holder and 3
Failure to properly install the fuse holder and 3
fuse to the PINK wire voids all product warran
fuse to the PINK wire voids all product warran
fuse to the PINK wire voids all product warran
fuse to the PINK wire voids all product warran
fuse to the PINK wire voids all product warran
Ignition Key Diagram for Steps 4-7
The vehicle’s wires are found coming off of the key switch.
Lock/Off
RUN
ACC
START
