Page 13
own Wire
Acc. Pulse
Control Harness
onal BROWN wire is the Accessory Pulse output which gives
nsistor ground output just as the Accessory wire comes on. This
tant in some vehicles to control the defroster or to control the
.P. system. Again, this is a 400 mA transistor ground output
MUST drive a relay (not included).
own/White
Alarm Disable
Control Harness
onal BROWN/WHITE wire will put out a quick negative pulse
re starting the vehicle. This wire can be used to turn off the
larm system in vehicles that have them.
On most vehicles, this wire can be connected directly to the
factory alarm/disarm wire which is usually located in the driver's
kick panel.
uired Final Steps
ying the Unit Out
NG: Be prepared to apply the brake during this testing. Close
d, fully apply the emergency brake, and place the vehicle in
Once all the wiring is checked and is correct, put the car
n park, then press the button on the transmitter of the
host alarm or keyless entry system which controls the
Secure Start.
The car should start and continue to run for ten min-
utes. Please make sure that the engine shuts down if the
ar is taken out of park, the hood is opened or the brake
s pressed.
Page 14
19. Trouble Shooting with the Self Diagnostics
The Secure Start® contains a built in diagnostic routine that w
cate why the unit turned off the car the last time that the unit w
To activate the diagnostic mode, simply turn the On/Off contro
to the “OFF” position. In a few seconds, the red LED on the mo
flash 1 to 6 times to identify the problem. See the chart belo
explanation of the flashes:
1 flash
10/15 minute time out/unit should be fine
2 flashes
Brake or Hood activated
3 flashes
No Tach or Stalled.
4 flashes
Received another remote input signal
5 flashes
Transmission was shifted into gear
6 flashes
Low battery voltage, or may be missing an
wire which powers up the alternator
In order to get an accurate diagnostic, allow the unit to go thr
complete starting cycle(s). The unit may only try to start once
try 3 times. In order to get an accurate reading, please wait 45
after its last attempt to start.
20. Special Programming Options
The Secure Start
®
unit has 8 special options and features. You
need to use these special options in most situations. The factory
will operate most vehicles. You must turn the On/Off contro
to the “OFF” position to program any features. Note that wh
ing off this control switch, the red LED will flash a few times, g
diagnostic code described in Section 20. Wait a few seconds
finish before programming your new Options.
#
Factory Setting (2 flashes) Option (1 flash)
1
“No-Tach”
Tach Mode
2
10 min. run time
15 min. run tim
3
Normal Crank
Extended Cran
4
Normal Crank
Super Crank
5
Normal Voltage Metering
Ignore Voltage M
6
Gasoline vehicles
Diesel vehicles
7
“Enable” feature
No “Enable”
8
Normal Trigger
Double Pulse T
(Channel Creat
