ARE NO USER SERVICEABLE PARTS INSIDE.
See electrical wiring instructions for installation.
Remark: Fill in the wall plates and mounting surface with silicone.
CAUTION: Before beginning installation disconnect power to the location where the light
will be installed by shutting that controls the light is not sufficient to prevent electrical
shock.
WIRING THE LIGHT CONTROL
Fixture is pre-wired for quick and easy installation for both professionals and do-it-yourself
alike:
DO NOT REMOVE ANY CRIPMP CONNECTORS PREINSTALLED!! ONLY WHITE, AND BLACK
WIRES WILL NEED TO BE ATTACHED TO INCOMING LINES!!
1. Check local electrical codes before installation. Use only 120 Volt 60hz
power supply.
2. Be sure power is turned off at breaker or fuse box. Turning switch off is not sufficient to
prevent electrical shock!!
3. Remove old light fixture.
4. The new fixture mounts best on standard 4
"
octagonal electrical box. If your box is an odd
size, you may need to purchase an additional base in a proper size from an electrical supplier.
Check size carefully before attempting to mount fixture.
5. Slide the black foam gasket over the white and black wires. It seals the base to the wall
when installed, helping keep moisture out.
