Meridian Series
Installation Instructions
Phoenix Lighting
8711 West Port Avenue Milwaukee, WI 53224 USA
Phone: +1 414.973.3300 Toll Free: 800.438.1214 Fax: +1 414.973.3210
www.phoenixlighting.com
1
!
CAUTION
•
All wiring should be done by a licensed electrician in accordance with state codes, local codes, and National Electrical Code (NEC) or International Electric
Commission (IEC) standards.
•
Improper installation may result in serious injury and void warranty.
•
Contains parts and assemblies susceptible to damage by electrostatic discharge (ESD).
•
Surge protective devices should be utilized for fixtures installed in environments subject to power surges outside the specified operating parameters.
Tools and Materials
(1) #3 Phillips head screw driver
(1) 3/4 inch wrench
(1) 9/16 inch wrench
(1) 1/2 inch wrench
(1) channel lock pliers
Mounting
There are several options available for mounting the Meridian Series. Installation instructions for the two primary options are provided below. Follow the one that
corresponds to your application.
Figure 2
Figure 1
6.4
3 mm
Pipe Mount
1.
Verify the voltage listed on the product label is the same as the voltage to be supplied to the fixture.
2.
Verify outer pipe diameter matches pipe mount adapter (Figure 1).
3.
Attach pipe mount adapter to the trunnion bracket using two 3/8 inch cap screws, two split lock washers and two flat washers. Torque screws to 24-27 N-m.
4.
Install cord grip to pipe mount using the cord grip nut provided (Figure 2).
5.
Thread power supply cord through cord grip on pipe mount adapter. Pull cord through so 300-380 mm remain on the fixture side of the adapter (Figure 2).
Tighten cord grip, hand tight plus ¼ turn.
6.
Lift fixture and slide pipe mount adapter onto pipe.
7.
Install four 5/16 cap screws into adapter. Rotate fixture to desired orientation and tighten screws to 13-16 N-m.
250 Model Weight
500 Model Weight
14.0 kg (31.0 lb)
18.0 kg (40.0 lb)
