Whenever possible, locate the unit so that its coverage area is away from heat sources or
reflective surfaces, such as heating vents, air conditioners, large moving trees or pools of
water. Whenever possible, locate the unit so that motion moves across the coverage area,
not directly towards or away from the motion sensor. It is because the motion sensor is
more sensitive to motion across it, not towards or away from it.
Note: The detection range specified above is based on the sensor
!
s performance in
conditions that represent average temperatures found in North America. The detection
range of the sensor will vary with changing ambient temperatures.
This fixture may be mounted on a wall or an eave. It may be mounted onto a standard
recessed outlet box or a wet location / outdoor outlet box. For easy installation, replace an
existing light fixture that is already connected to a wall switch.
Since the holes on the backplate are not pre-drilled, drill the holes by electric drill as
needed to mount the backplate with junction box.
WARNING: Maintain minimum 1.5
"
(3.8cm) distance between lampholders and sensor head.
Do not point lampholders directly at ceiling; possible fire hazard. Do not let lamps touch
ceiling. Keep a minimum 2
"
distance from ceiling.
TIPS FOR PROPER OPERATION
1. For optimal operation and optimal coverage area mount unit 6 to 8ft. above ground on
house overhang or wall.
2. Mount away from heat producing sources such as air conditioners & barbecue grills, other
light fixtures or sources of light. Keep in mind areas with traffic, pets or other moving objects
may cause nuisance triggering.
3. Do not aim at highly reflective surfaces such as smooth white walls, waterfalls, or windows.
4. Point sensor slightly downward. Do not mount up facing sun.
5. If you are unfamiliar with electrical wiring, it is recommended you secure the services of
qualified electrician who can assure this installation meets national and local electrical
codes.
ASSEMBLY
If you already have outdoor lights in the location you intend to mount the new fixture, you
simply disconnect old fixture and remove. Follow steps for wiring the new units to existing
electrical box. If you do not have power to that location, a new outlet box and wiring must
be installed. DO NOT ATTEMPT TO DISASSEMBLE THE MOTION SENSOR HEAD. THERE
