ENGLISH
Operation
1) Connect the Solar Panel to Lamp with about 5 meters Wires by insert plug into the
lamp “INPUT” socket at the lamp bottom (see figure 14). Turn the switch to the “AUTO”
position, it will automatically charge at daytime and work during the night time.
2) Adjust the “SENSOR LEVEL” switch at the bottom
of the Lamp Body to change the working time
earlier or later in the night.
3) Adjust the “DURATION” switch at the bottom of
the Lamp Body to change the lamp operating
period after detecting.
4) Turn the switch to the “ON” position, the lamp
will be constantly lighting and the motion
sensor does not work.
5) The performance of the SOLAR LAMP will vary
with the time of year. It will deliver more light when it has had a full day in the sun
rather than a day in overcast weather.
Replacing the Batteries
For best results batteries should be replaced every 12 months.
1) Detach the housing from Lamp Body by pushing it downward.
2) Take off the 4 screws with Screwdriver and Replace the old batteries. Make sure the
new batteries are rechargeable batteries.
3) Install the new batteries in to the battery compartment, ensuring the correct polarity is
observed.
4) Reassemble the unit by reversing the above procedure.
Trouble Shooting
If your SOLAR LAMP does not come on at dusk despite observance of all the instructions,
please try the following steps:
1) Make sure that the SOLAR LAMP is not being affected by any other light source.
2) Ensure the SOLAR LAMP does not stand in the shade during the day.
3) Make sure the switch is in the auto position.
4) Check that the batteries are installed correctly.
