DESIGN-AIRE SL-RSR-EC
Installation and Operations Manual
Revision: 28-Jan-16
Page 10 of 15
86 Harry Douglas Dr., Ottawa, ON, K2C 2C7
T: 613-831-8318, TF: 1-888-636-8609
DESIGN FILTRATION MICROZONE INC.
www.dfmzgroup.com
1.
Position the corresponding sized support strip over the edge of the filter frame as shown in the photo.
In most cases the short filter support strips should be installed first.
2.
Push the filter up into the hood, applying force only to the support strips and filter frame.
3.
Once the filter is inserted far enough into the frame, slide the support strip into the groove as shown
below. This locks the filter into position.
4.
The support strips must be fully inserted into the groove so that the ridge on the filter frame is visible
from below.
12. MOTOR/ELECTRICAL
Design-Aire uses 230-volt, energy efficient backward curved impellers to provide excellent airflow distribution,
quieter noise levels and low heat loads. No maintenance is required for the motors, although a periodic
inspection for dirt build up is recommended. Dirt on your motor can cause vibrations and shorten the life cycle
of the motor.
The standard variable speed controller comes complete with on/off switch to help increase filter life cycle. A
duplex outlet located on the pre-filter assembly enables units to be joined together in series, thus helping
reduce additional up front in house electrical costs, up to six units or 10-amps may be plugged into the duplex.
A standard FT2 type 3-prong electrical cord is included with your Design-Aire. Always check local electrical
codes prior to installing your Design-Aire unit.
1.
2.
3.
4.