www.fmiproducts.com
124387-01A
6
Figure 2 - Possible Locations for
Installing Appliance
INTERNAL WALL
INSTALLATION
CORNER
INSTALLATION
FULL
PROJECTION
INSTALLATION
FLUSH
INSTALLATION
SELECTING LOCATION
7R GHWHUPLQH WKH VDIHVW DQG PRVW HI¿FLHQW
location for your appliance, you must take into
consideration the following guidelines:
1. The location must allow for proper clear-
ances (see clearance information on
page 10).
2. Consider a location where heat output
would not be affected by drafts, air con-
ditioning ducts, windows or doors.
3. A location that avoids the cutting of joists
or roof rafters will make installation easier.
Figure 1 shows a plan view of a few com-
mon locations.
Flush installations
are recommended where
living space is limited or at a premium and
since the space required to enclose the ap-
pliance would be located beyond an outside
wall, this would also reduce the cutting of
joists, roof rafters and such. Check local
codes for any restrictions.
3URMHFWHG LQVWDOODWLRQV
can extend any
distance into the room. A projection may
be ideal for a new addition on an existing,
¿QLVKHGZDOO
Corner installations
make use of space
that may not normally be used and provides
DZLGHUDQGPRUHHI¿FLHQWUDQJHIRUUDGLDQW
heat transference.
,QWHUQDOZDOOLQVWDOODWLRQV
provide a discreet
option for room separation and can also be
ideal as an addition to an existing wall.
