www.fmiproducts.com
124387-01A
29
PILOT AND BURNERS
5HPRYHPDWHULDOEHIRUHFOHDQLQJEXUQHUV
and replace when cleaning is complete.
%XUQHUDQGFRQWUROVVKRXOGEHFOHDQHGZLWK
compressed air to remove dust, dirt or lint.
8VHDYDFXXPFOHDQHURUVPDOOVRIWEULVWOHG
brush to remove excess dust, dirt or lint.
LOGS
8VH D YDFXXP FOHDQHU WR UHPRYH DQ\
carbon buildup on logs.
5HSODFHPDWHULDOSHULRGLFDOO\DVQHHGHG
See
Replacement Parts
, page 43.
VENTING SYSTEM
Conduct annual inspection of the venting
system following these guidelines:
1. Check areas of venting system that are
exposed to the weather for corrosion (rust
spots or streaks and, in extreme cases,
holes). Have these items replaced im-
PHGLDWHO\E\DTXDOL¿HGVHUYLFHSHUVRQ
5HPRYHWKHYHQWFDSDQGVKLQHDÀDVK
-
light into the vent. Remove any foreign
material.
3. Check for evidence of excessive con-
densation. Continuous condensation can
FDXVHFRUURVLRQRIFDSVSLSHVDQG¿WWLQJV
and can be caused by having excessive
lateral runs, too many elbows or exterior
portions of the system being exposed to
cold weather.
4. Inspect joints to verify that no pipe section
RU ¿WWLQJ KDV EHHQ GLVWXUEHG DQG ORRV
-
ened. Check mechanical supports such
as wall straps for rigidity.
OUTSIDE AIR AND DAMPER
HANDLE OPERATION
The damper handle, which opens and closes
the damper blade, is located in the upper front
IDFHRIWKH¿UHSODFH3XVKLQJWKHKDQGOHIRU
-
ward and up through the keyway slot will free
damper blade to automatically open. Pushing
the handle forward and down will lock damper
blade closed (see Figure 48).
Figure 48 - Operating Damper Handle
Damper
Weight
To Close
Damper
To Open
Damper
Damper
Weight
CLEANING AND MAINTENANCE
Continued
REPLACING BATTERIES IN HAND-
HELD REMOTE CONTROL AND AC
BATTERY BACKUP
Replacing Batteries in AC Battery
%DFNXS
1. Remove bottom access door.
2. Remove battery pack from metal housing.
3. Remove existing batteries. Install 4 AA
batteries into battery pack following posi-
tive and negative directions.
4. Insert battery pack back into metal hous-
ing.
5. Replace bottom access door.
,QVWDOOLQJ%DWWHULHVLQ5HPRWH&RQWURO
Unit
1. Remove battery cover on back of remote
control unit.
2. Remove
battery.
3. Install 1 A23/12V battery following positive
and negative directions.
4. Replace battery cover onto remote control unit.
