DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
Desco.com
TB-3069
Page 4 of 7
© 2016 DESCO INDUSTRIES, INC.
Employee Owned
Installation
The Combo Tester is portable when powered by a 9V
alkaline battery, but it also has the flexibility of being
permanently installed at a location. Use the three
keyhole slots located on the back of the Combo Tester
to mount it to a wall or stand.
INSTALLING THE
19280
/
19283
COMBO TESTER
1. Install the 9V alkaline battery into the Combo
Tester.
2. Select a location to mount the Combo Tester.
3. Install three #6 or #8 screws into a wall or other
vertical surface as shown in the figure below. Make
sure that the screw heads do not project out more
than 1/4" from mounting surface.
INSTALLING THE
19282
COMBO TESTER WITH
STAND AND FOOT PLATE
1. Position the pedestal on top of the foot plate with
the mounting bracket sloping toward the operator.
Secure the pedestal to the foot plate using the 3
included button head screws and allen wrench.
Figure 8. Combo Tester keyhole slots
4. Mount the Combo Tester onto the screws, and pull
it down to secure it into place.
5. Set the Stainless Steel Foot Plate below the tester
(if applicable).
6. Insert the 6' long foot plate cord’s banana plug into
the Combo Tester’s foot plate jack.
Figure 9. Inserting the foot plate cord’s banana jack into
the Combo Tester
7. Snap the opposite end of the foot plate cord onto
the Stainless Steel Foot Plate.
Figure 10. Securing the pedestal to the foot plate
2. Install the 9V alkaline battery into the Combo
Tester.
3. Mount the Combo Tester onto the pedestal’s
mounting bracket and flat head screw, and screw
down to secure it into place.
4. Insert the 5" long foot plate cord’s banana plug into
the Combo Tester’s foot plate jack.
5. Attach the foot plate cord’s ring terminal to the flat
head screw located at the back of the pedestal’s
mounting bracket, and tighten the knurled nut to
secure.
Figure 11. Installing the Combo Tester to the pedestal
6. Cover the knurled nut and flat head screw with
included insulative vinyl cap.
7. Install the included poster at eye level nearby the
test station.
