TB-3072
Page 4 of 6
© 2018 DESCO INDUSTRIES INC
Employee Owned
DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
Desco.com
Installation onto Micastat® Laminate
Materials Needed:
2
14244
Micastat® Flush Mount Ground Inserts
1
14242
Micastat® Flush Mount Insert Tool
1
09857
10mm Socket and Rivet (100 per pack)
2 8-32 Button Cap Screws
1. Install the two flush mount ground inserts into the
Micastat® laminate. Space the inserts 1-5/16" apart
from one another.
2. Once the ground inserts are installed, remove the
8-32 screws that were supplied with the kits.
3. Place 10mm snap sockets on top of the installed
brass ground inserts.
4. Screw the 10mm snap sockets into place on the
ground inserts using the 8-32 button cap screws.
5. Align the two snaps underneath the Mini Monitor
to the two snaps on the Micastat® laminate. Apply
downward force on the monitor once aligned to
snap the Mini Monitor into place.
6. Connect the power adapter to the power jack
located on the top-side of the Mini Monitor. Route
the wire from the supply to a nearby AC outlet
and plug it into the outlet. Make sure the voltage
and frequency match those listed on the power
supply. The Mini Monitor is now powered, and the
Micastat® laminate is now grounded.
10mm Park Snap and 10mm Operator Jack Adapter
The
19243
Mini Monitor includes an interchangeable
10mm park snap and 10mm banana jack adapter for
operators who use wrist cords with 10mm terminations.
Use the park snaps' knurled rims to unscrew the 4mm
park snap from the monitor and install the 10mm park
snap to the monitor. Plug the 10mm operator jack
adapter into the monitor's operator jack.
Installation
1. Remove the Mini Monitor from the carton, and
inspect for damage.
2. Locate an appropriate AC outlet near the Mini
Monitor, and test it for proper wiring and grounding
prior to use. The Desco AC Outlet Analyzer or
similar test equipment may be used to verify the
outlet’s functionality. Use item number
98132
for
120VAC North American outlets and item number
98131
for 220VAC UK outlets.
3. Determine the mounting location of the Mini Monitor.
It is normally installed toward the front edge of a
workstation where its LEDs can be visible to the
operator. Use a blade to pierce two holes 1-5/16"
apart from one another into the worksurface mat.
4. Use a Phillips screwdriver to secure the two flathead
screws and countersunk washers through the
worksurface mat and into the two threaded 10mm
snaps on the bottom of the Mini Monitor.
Figure 7. Changing the park snap on the
19243
Mini
Monitor
Figure 5. Securing the Mini Monitor to a worksurface mat
5. Connect the power adapter to the power jack
located on the top-side of the Mini Monitor. Connect
the wire from the supply to the tested AC outlet, and
plug it into the outlet.
NOTE: Older revision Mini Monitors do not feature
threaded 10mm snaps on their bottom-side. They
require the use of push and clinch snaps to secure the
monitor to the worksurface mat.
