![background image](http://html.mh-extra.com/html/desa/vsgf36nrc/vsgf36nrc_owners-operation-and-installation-manual_2486145028.webp)
www.desatech.com
121082-01G
28
TROUbLEShOOTING
Continued
OBSERVED PROBLEM
POSSIBLE CAUSE
REMEDY
Slight smoke or odor during
initial operation.
1. Not enough air.
2. Gas regulator defective.
3. Residues from manufac-
turing processes and logs
curing.
1. Check burner for dirt and
debris. If found, clean burner
(see
Cleaning and Mainte-
nance
, page 25).
2. Replace gas control.
3. Problem will stop after a few
hours of operation.
Moisture/condensation no-
ticed on windows.
1. Not enough combustion/
ventilation air.
1. Refer to
Air for Combus-
tion and Ventilation
require
-
ments (page 7).
Heater produces a whistling
noise when burners are lit.
1. Turning control knob to HI
position when burners are
cold.
2. Air in gas line.
3. Air passageways on heater
blocked.
4. Dirty or partially clogged
burner orifice(s).
1. Turn control knob to LO
position and let warm up for
a minute.
2. Operate burners until air is
removed from line. Have gas
line checked by local natural
or propane/LP gas company.
3. Observe minimum installation
clearances (see page 10).
4. Clean burners (see
Cleaning
and Maintenance
, page 25)
or replace burner orifice(s).
White powder residue forming
within burner box or on adja-
cent walls or furniture.
1. When heated, vapors from
furniture polish, wax, carpet
cleaners, etc. may turn into
white powder residue.
1. Turn heater off when using
furniture polish, wax, carpet
cleaners or similar products.
Remote does not function.
1. Battery is not installed. Bat-
tery power is low.
2. Wire connection loose or
wire broken.
1. Replace batteries (4-AA in
receiver and 3-AAA in hand
set) in receiver and remote
control.
2. Check wiring connections
(see
Wiring Diagram
, page
30). Replace wiring harness
if necessary.
Yellow flame in front burner
during burner combustion.
1. Not enough air.
2. Gas regulator defective.
1. Check burner(s) for dirt
and debris. If found, clean
burner(s) (see
Cleaning and
Maintenance
, page 25).
2. Replace gas regulator.
Fireplace produces a clicking/
ticking noise just after burner
is lit or shut off.
1. Metal expanding while
heating or contracting while
cooling.
1. This is normal with most
heaters. If noise is exces-
sive, contact qualified ser
-
vice person.