![background image](http://html.mh-extra.com/html/desa/vl42lzpr/vl42lzpr_owners-manual_2486096023.webp)
www.desatech.com
115254-01B
23
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the con
-
trol button again until burner turns off (see
Figure 33).
To Lock
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Figure 32 - Setting the Selector switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
O
FF
P
ILO
T
LO
IH
ON
OFF
REMOTE
O
N
Selector Toggle Switch
(Optional Remote Control)
Control Knob in
On Position
Flame Adjustment
Knob
OPERATION
Continued
REMOTE-READY MODELS
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
to the
OFF position.
2a. Set selector switch in the OFF position.
2b.
If Using Optional Hand-Held Remote:
Set selector switch in the OFF position to
prevent draining battery.
3. Close equipment shutoff valve (see Figure
15, page 15).
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions
, page 21.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob. Now
follow steps 9 and 11 under
Lighting
Instructions
, page 22.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 41). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re
-
mote control unit. See
Lighting
Instructions
on page 21.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi
-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Slide the selector switch
to the REMOTE position (see Figure 32).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Figure 33 - On/Off Hand-Held Remote
Control Unit (HRC100)
Control
Button
Indicator
Light
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated
using either the manual mode (MANU) or
thermostatic mode (AUTO) (see Figure 34,
page 24). To select Fahrenheit/Centigrade
mode display, carefully press the ˚C/˚F mode
button with the end of a paper clip or similar
blunt object.