![background image](http://html.mh-extra.com/html/desa/vl42lzpr/vl42lzpr_owners-manual_2486096017.webp)
www.desatech.com
115254-01B
17
Figure 19 - Installing Vintage Oak Two-
Piece Log Set (Top View)
Two Piece Log Set
Burner Ports
INSTALLING LOGS
Models L36(EN, LEN, EP, LEP) and
VL36(EN, LEN, EP, LEP)
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place front logs (1L and 1R) on top of
grate. Make sure notches in bottom of logs
fit over grate prongs (see Figure 20).
2. Rest bottom of center log (#2) behind
metal posts on front burner (see Figure
21). Make sure grooves in bottom of log
fit over grate. Bring log forward against
metal posts.
INSTALLATION
Continued
Figure 20 - Installing Front Logs
Front Logs
Notch
Grate
Prong
IMPORTANT:
Make sure logs do not cover
any burner ports (see Figure 19).
3. Place lava rock around base of heater if
desired.
Figure 22 - Installing Rear Log (#3)
Figure 23 - Installing Crossover Log (#4)
3. Slide groove on back of rear log against
rear grate prongs. Make sure peg on the
log is on top (see Figure 22).
4. Place crossover log on rear and middle
logs. Make sure peg on rear log is in the
hole in bottom of crossover log. Crossover
log should fit in cutout of middle log (see
Figure 23).
Rear Log (#3)
Rear
Grate
Prong
Crossover
Log (#4)
Peg
Figure 21 - Installing Center Log
Center Log (#2)
Grate
Metal Post
Metal
Post