![background image](http://html.mh-extra.com/html/desa/vanguard-vvtr18/vanguard-vvtr18_owners-operation-and-installation-manual_2485974012.webp)
12
901847
VENTED NATURAL GAS LOGS
®
LIGHTING
INSTRUCTIONS
OPERATING
APPLIANCE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some gas is
heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
1.
STOP! Read the safety information,
above.
2.
Turn the gas shutoff valve to OFF.
3.
Wait five (5) minutes to clear out any
gas. If you then smell gas STOP! Fol-
low the safety information above. If
you don't smell gas, go on to the next
step.
4.
Light a match and lay it on top of the
"U" shaped burner near the edge of
the cover on the right side of the pan.
5.
Slowly turn the gas shutoff valve ON
until the burner ignites. If the burner
doesn’t ignite within 10 seconds with
the match burning, turn the shutoff
valve OFF and repeat steps 1 through
4 again.
WARNING: Keep flue open
when operating unit.
INSTALLATION
Continued
Figure 18 - Installing Ember Bed
Figure 19 - Installing Back log
Grate
Ember Bed
Figure 20 - Installing Logs
Figure 21 - Installing Logs
INSTALLING THE EMBER
BED AND LOGS (Cambridge
Split Log Set Shown)
1.
Place the ember bed (included with
burner set) over log grate as shown in
Figure 18.
2.
Position the back log flush against back
of ember bed as shown in Figure 19.
3.
Place the middle layer of logs as shown
in Figure 20. Notice the grove in the
back log for placement of log to the far
right. Adequate space should be left
between logs and ember bed for flames.
4.
Place the top layer of logs as shown in
Figure 21.