www.desatech.com
110749-01E
11
Figure 9 - Inserting Firebox Into Cabinet
Mantel (Mantel May Vary From Illustration)
installation
Continued
INstAllING GAs lINe
warninG: a qualified ser
-
vice person must connect heater
to gas supply. follow all local
codes.
IMPORTANT:
See
Connecting to Gas Supply
in your log set owner’s manual for details on
gas hookup.
You may run the gas line from either side of
the firebox (see Figure 11). Decide which side
you want to run the gas line from.
Note: This is one option for installing shutoff
valve. Check local codes for equipment shut-
off valve location requirements.
Figure 10 - Installing Gas Line and
Equipment Shutoff Valve (Model May
Vary From Illustration)
Knockout Locations
(Knock Out One Hole)
Gas Line Hole
Locate recessed knockout in one of the fire
-
brick sidewall liners (see Figures 10 and 11).
Firmly tap center of knockout with a chisel
until it is released. Carefully chisel rough
edges of hole you have made until edges
are smooth. This hole will line up with hole
in outer casing.
cAutIoN: do not use exces-
sive force to remove the knock-
out. too much force may damage
the firebrick concrete insert.
Equipment
Shutoff Valves
(Install One)
1
3
/
8
" Thick Liner
Figure 11 - Location of Knockout for Gas
Line
Knockout
Chisel
Firebrick Side Wall
Remove
this Area
Side
View
5. Install and properly test gas log heater.
Follow installation instructions included
with the vent-free gas log heater that is
being installed.
