![background image](http://html1.mh-extra.com/html/desa/sdvbnc/sdvbnc_owners-operation-and-installation-manual_2486404009.webp)
107304
For more information, visit www.desatech.com
For more information, visit www.desatech.com
9
9
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
4.
Thermostat Blower Only:
Attach thermal switch and bracket
to inside rear cover wall with two hex head screws provided as
shown in Figure 17, page 8. After securing bracket to rear cover,
carefully bend along existing bend line on bracket to almost a
90
°
angle (see Figure 17, page 8). This will allow thermal switch
to be positioned against stove rear wall and sense temperature
when in operating mode.
5.
Place speed control on left inside of rear cover and push the
plastic control shaft through opening (see Figure 17, page 8).
6.
While supporting speed control, secure control shaft with lock nut
by pushing and turning lock nut with pliers clockwise until tight
against the side of rear cover. Place control knob provided onto shaft.
7.
Place the green ground wire between the bottom hole on the
blower assembly and the hex screw and tighten (see Figure 18).
8.
Connect the blue wire on the blower assembly to one side of
the thermal switch (see Figure 18).
9.
Connect the black wire to the other side of the thermal switch
(see Figure 18).
10. Connect the white wire to the other terminal on the blower mo-
tor assembly (see Figure 18). Make sure the thermal switch has
been properly installed to fit against back of fireplace insert af-
ter the rear cover assembly has been reinstalled.
11. Make sure all wire connections to terminals on blower motor
and thermal switch are securely attached and that the screw
retaining the green ground wire is tight.
Green Ground Wire
Wiring
Diagram
Decal
Speed
Control
Black
Wire
White
Wire
Blue Wire
Power Cord (Route Through
Plastic Bushing in Bottom
Cover When Assembled)
Screw
Thermal
Switch
WARNING: Never touch the blower wheel while in
operation.
WARNING: Failure to position the parts in accor-
dance with supplied diagrams or failure to use only
parts specifically approved with this heater may result
in damage or personal injury.
Figure 18 - Blower Wiring Layout (Thermostat Blower Shown)
12. Check to make sure that the power cord is completely clear of the
blower wheel and that there are no foreign objects in blower wheel.
13. Peel off the backing paper and stick the supplied wiring dia-
gram decal on the inside of rear cover as shown (see Figure 18).
14. Reattach bottom cover to rear cover with 8 screws (see Figure
16, page 8). Make sure that you don’t pinch any wires during
reassembly. Route power cord through plastic bushing in bot-
tom of rear cover.
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Installing Optional Blower Accessory (Cont.)
Installing Rear Cover
INSTALLING REAR COVER
1.
Place rear cover behind stove body. Rear cover will rest on the
bottom ledge of the stove body.
2.
Place wire harness from ON/OFF switch under the cast of
stove body.
3.
Using hex screws provided, attach rear cover to back of stove
body. See Figure 19.
IMPORTANT:
This rear cover must be
securely in place before venting pipes are installed.
Rear Cover
(Shown with
Optional
Blower)
Hex Screws
Blower
Power
Cord
ON/OFF
Switch Wire
Harness
ON/OFF Switch
Figure 19 - Installing Rear Cover (Shown with Optional Blower
Accessory)