www.desatech.com
110882-01K
18
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Each log is marked with a number. These numbers
will help you identify the log when installing. It
is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place front log (#1) on top of the grate. Make
sure the notches in the bottom of the log fit
over the grate prongs (see Figure 26). Push
back of logs flush with metal grate bars.
2. Rest middle log (#2) behind metal posts on grate
assembly. Make sure the grooves in the bottom
of the log fit over the grate. Bring the log forward
next to the metal posts (see Figure 27).
3. Slide the grooves in the back of the rear log
(#3) against the rear grate prongs. Make sure
the log fits securely over the prongs (see Fig
-
ure 28). Make sure log is completely vertical
and not leaning in toward burner where the
flame will touch the log.
INSTALLATION
Continued
Middle Log (#2)
Metal Post
Groove
Groove
Grate
Figure 27 - Installing Middle Log (#2)
Rear Log (#3)
Grate
Prong
Groove in
Back of Log
Figure 28 - Installing Rear Log (#3)
Front Log (#1)
Grate
Prongs
Base
Assembly
Bars
Figure 26 - Installing Front Log (#1)
Notch
Note:
Your appliance may vary from model shown
but log placement will be the same.
Grate
Prong
Groove
in Back
of Log
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control unit.
Figure 25 - Installing Battery in Hand-
Held Remote Control Unit
Battery Cover
9-Volt Battery
Terminal
Wires
Remote Control Unit
Battery
Housing
