![background image](http://html1.mh-extra.com/html/desa/nz108/nz108_safety-information-and-installation-manual_2485917015.webp)
www.desatech.com
15
119171-01E
Figure 22 - Burner Patterns
Figure 21 - Pilot
Ignitor
Electrode
Pilot
Burner
Thermocouple
OpERATING HEATER
Continued
TO SELECT
HEATING LEvEL
WARNING: When running
heater, set control knob at
locked positions. Never set
control knob between locked
positions. Poor combustion
and higher levels of carbon
monoxide may result.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Turn thermostat control knob counterclockwise
to the desired heating level. The main
burner should light. Set control knob to any
heat level between 1 and 5 (see Figure ).
6. Turn control knob counterclockwise
to the PILOT position. Press in control
knob for five (5) seconds.
7. With control knob pressed in, push down
and release ignitor button. This will light
pilot. The pilot is attached to the front of
burner.
Note:
You may be running this
heater for the first time after hooking up to
gas supply. If so, you may need to press in
control knob for 0 seconds or more. This
will allow air to bleed from the gas system.
If needed, keep pressing ignitor button until
pilot lights. If ignitor does not light pilot, re
-
fer to
Troubleshooting
, page 18 or contact
a qualified service person or gas supplier
for repairs. Until repairs are made, light
pilot with match. To light pilot with match,
see
Manual Lighting Procedure
.
8. Keep control knob pressed in for 0 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop up when
released, contact a qualified service
person or gas supplier for repairs.
Note:
If pilot goes out, repeat steps 4
thru 7.
9. Turn control knob counterclockwise
to desired heating level. The main burner
should light.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Figure 20 - Control Knob In The OFF
Position
OF
F
P
ILO
T
Control
Knob
Ignitor
Button
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
to the
OFF position.
. Turn off all electric power to the appliance
if service is to be performed.
Shutting Off Burner Only (pilot stays lit)
Turn control knob clockwise
to the
PILOT position.
MANUAL LIGHTING
PROCEDURE
1.
Remove front panel (see Figure 6, page 9).
. Follow steps 1 through 7 under
Lighting
Instructions
, page 14.
3. With control knob pressed in, strike match.
Hold match to pilot until pilot lights.
4. Keep control knob pressed in for 0 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow step 9,
under
Lighting Instructions
.
5. Replace front panel.
Control Knob
burners