2
598-1311-00
INSTALLATION
For easy installation, select an existing light with a wall
switch for replacement.
For best performance, mount the fi xture about 8 ft.
(2.4 m) above the ground.
W
IRE
THE
L
IGHT
C
ONTROL
B
ULB
I
NSTALLATION
❒
When relamping,
turn power off
and let the fi xture
cool.
❒
Remove glass cover and remove the old bulb by
pushing the bulb towards the socket indicated on
the metal refl ector.
❒
To insert the new bulb, follow the instructions printed
on the metal refl ector.
❒
Check that the bulb is seated properly.
❒
Reinstall the glass cover.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fi xture to cool before touching. The bulb and
the fi xture operate at high temperatures.
• Keep fi xture at least 1" (2.5 cm) from combustible ma-
terials. Do not aim at objects closer than 3 ft. (1 m).
• Use only T3, 250W (max.) tungsten halogen 120
VAC lamps.
White
to
White
Black
to
Black
Connect any fi xture ground wire(s) and the cover plate
ground screw to the junction box ground wire.
Gasket
Mounting Strap
Mounting
Bolt
M
OUNT
THE
L
IGHT
C
ONTROL
❒
Align the Light Control cover plate and cover plate
gasket. Secure with the mounting bolt.
❒
Push the Rubber Plug fi rmly into place.
❒
If a wet location junction box was not used, caulk
the wall plate mounting surface with silicone weather
sealant.
For eave mount only:
❒
Swing the sensor head towards the clamp screw
joint.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
❒
Then rotate the sensor head clockwise 180° so
the controls face down.
Controls
Eave Mount
For under eave installation, the sensor head must be
rotated
as shown in the next two steps for proper operation
and to avoid the risk of electrical shock. Also
for proper
under eave operation,
remove the protective backing
from the Light Shield and stick on as shown below.
Controls
Controls
Clamp Screw
Wall Mount
Lens Retainer
Light Shield,
with opening at
this side
❒
Note the position of the various parts of the fi xture for
the type of installation for your application and adjust
the lamp head and sensor as shown below.
Lens Retainer
Light Shield
Opening
Rubber
Plug
WARNING: Turn power off at circuit breaker
or fuse.
❒
Remove the existing light fi xture.
❒
Install mounting strap to junction box using screws
appropriate for your junction box.
❒
The plastic hanger can be used to hold the fi xture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
❒
Thread all fi xture wires through the large holes in
the gasket as shown.
❒
Connect the junction box wires to the light fi xture
wires as shown. Twist together and secure with wire
connectors.
