INSTALLATION
Continued
4. Place right front log (log #4) on peg of log #3 and
grate prongs as shown in Figure 22, page 16.
5. Place left crossover log (log #5) on pegs of
log #2 and #3 (see Figure 23). Place middle
crossover log (log #6) on pegs of log #1 and #2
(see Figure 23). Place right crossover log (log
#7) on pegs of log #2 and #4 (see Figure 23).
6. Slide control cover log (log #8) into place be
-
tween front logs #3 and #4 (see Figure 24).
Figure 23 - Placement of Crossover Logs
(Logs #5, #6, and #7)
Log #5
Log #
Log #7
Figure 24 - Control Cover Log (Log #8)
Placement
Log #8
OPERATING HEATER
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand, don’t
try to repair it, call a qualified service tech
-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a quali-
fied service technician to inspect the appli
-
ance and to replace any part of the control
system and any gas control which has been
under water.
